Purpose:
Depending on what servo's are in use or desire to push the servo beyond stock amount of throw, the flysky firmware allows you to bump up the End Point setting a little bit.
How to access this sub menu:
The Maximum End Point Value mini menu is accessible from the the Global Menu. It should be the sixth mini menu upon entering the Global Menu. To find it scroll till there is an E shown on the seven segment display.
- Starting from the Home Screen
- Press enter-LONG
- Scroll till E is shown on the seven segment display
- Press enter-SHORT
How to use this menu:
There is only one parameter that can be changed in this mini menu, the Maximum End Point Setting parameter. After entering the mini menu, the scroll wheel can change the max perrcentage the end point adjuster can be set to. Anywhere between 100% to 150%. Observe the warning shown at the bottom of the page.
- Use the scroll wheel to adjust the Maximum End Point Setting parameter
- Press enter-SHORT to return to the global menu
- Or press enter-LONG, END, or BACK to exit the menu.
Screen Indicators:
While the End Point Value mini menu is open, the following should occur
- The Model and Name icon at the top of the screen will be flashing back and forth
- There will be an E in the seven segment display
- There will be a % sign displayed on the far right hand side of the screen
WARNING
Adjusting this setting beyond 120% could cause glitches, harm to your radio, or harm to the servo.